wall

  1. Knee wall

    Knee wall

    cold wall in shop
  2. flatheadfisher

    Wall's Tomorrow?

    I am trying to get motivated to get up and go to Wall's Lumber tomorrow. If you live near Winston-Salem and would like to ride out there with me, let me know. You can send me an email at $michaelvayers@me.com$ - just delete the "$" at the ends. It will go to my iphone & I will get it immediately.
  3. Matt Schnurbusch

    1/2" bow in wall

    I am nearing the end of a laundry room makeover for my SIL, and right at the last of it I ran into an issue. She wants white counter tops installed for the folding area. I measured the length and had them fabricated. What I failed to take into account was the drastic bow in the long wall. So...
  4. sediener

    Safely terminating a live wire in the wall.

    I've got some under counter lighting which are direct wired. I'm planning to replace 2 single bulb fixtures which are in the corner with a single three bulb fixture (the old ones seem to be getting overheated and turn off randomly). So I have two wires hanging out of the wall and only need...
  5. Tarhead

    Free Download Greene and Greene Wall Lamp Plan

    http://www.woodworkersjournal.com/Uploads/Public/Documents/Issue237/WJ061_AC_Wall_Lamp.pdf
  6. zapdafish

    MDF Wall Cabinets

    I've needed wall storage in my garage for quite some time now. I have 3 sheets of 3/4 MDF for another project that a friend decided not to go through with. As it's for my garage I don't really care that its going to be made of MDF and those sheets are driving me crazy. I have found tons of...
  7. mdelgiorno

    Walnut wall panels - miter madness!

    Here's an in-progress shot of some walnut wall paneling I'm putting up in my home/office. I couldn't find any overlay molding that I liked, so I sketched some up and the Hardwood Store in Gibsonville did a great job making it. Maybe I should have thought about the number of miter cuts before I...
  8. Walnut wall

    Walnut wall

    In-progress shot of some walnut wall paneling I'm putting up in my home/office.
  9. TN Woodie

    New House/Shop ... Roof... Photo Update 4/15

    OK, I am building a new shop, is should be 70 x 28 with a garage door at one end. It will also double as the support for the walls of our new house. Yes, this is a basement, full daylight on two sides and will be shop and working garage as there is also a garage on the main level that will be...
  10. PChristy

    Dry Wall mud

    Does anyone know if you can patch the old plaster with dry wall mud? We are working on an old house where the paint has peeled off of the walls and the plaster has cracked in alot of places - what is the best way to patch this
  11. H

    Basement wall insulation? Advice sought

    I am re-finishing our 70's era faux paneling basement. The drywall is already on the ceiling (75% at least) and I have about half of the paneling off the walls. The exterior block walls have 1x4 installed on the flat with concrete nails. There is Al foil vapor barrier installed between...
  12. MrAudio815

    Wall Box Shelves

    Hey Everyone, I made these a few weeks ago, but had to sand them and add a little more paint and wait to dry. :roll: Had them on the floor for a few days, and the wife said thats it, put them up (Sunday).:eusa_naug She said I have had enough fun getting the lathe, going here, going there...
  13. woodArtz

    NCWW Calendar on the wall

    I put up the new NCWW calendar today. Man, is that sharp. The guitar and chest of drawers is beautiful. If you don't have an NCWW calendar, run, don't walk to http://www.cafepress.com/ncwoodworker#link-productCategory-103
  14. rcflyer23

    Corian Wall Street

    Well I was never sure about the corian pens. I haven't really like many but I was in the Greensboro Woodcraft today and they had some so I just had to give them a try. I think it turned out pretty good the pictures are not but the pen look pretty cool. It's copper trim, it's hard to tell in...
  15. K

    wall storage for wood

    For a multitude of reasons the latest try at moving and ending up with a new shop failed. This leads me to going ahead with building a wood storage rack on a sheet rock and stud wall. The wall is 10 feet high. I have about 18 feet in length up to about 5 feet and then electrical panels limit...
  16. S

    wall bookshelf

    .
  17. J

    Blast Gate Wall Support

    If you have ever tried to rig up something to support a blast gate, Rockler now has a wall support. Saw them in the newest catalog. They fit both plastic and metal gates. After IWF, I will be able to give a report on how they work. One is $3.99, and a set of four is $12.99. Item #'s 26813, and...
  18. jaustin

    walnut from steve wall lumber

    Went this morning and pick up a load of walnut from Wall Lumber. This is the 100bdft manger special for $395 it is surfaced 2 sides. I have already used 3 boards out of the stack.Widest was about 8 1/2 narrowest was 4 1/5. most of it was 6-7 in Right around 6ft long + or - a inch or two...
  19. Bigdog72

    Steve Wall Lumber

    Anybody making a trip to Steve Wall Lumber any time soon? I need some poplar.
  20. LeftyTom

    Wall Mounted Jewelry Armoire??

    LOML wants one for our 15 anniversary (April '08). I've seen a few online, but not quite what she has in mind. She wants one with enough height for necklaces (on 18" chains) do not touch the bottom of the compartment, enough ring rolls for a dozen rings, and two or three drawers for earrings...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top