yup

  1. froglips

    Drawbore pins - yup, I made'm myself!

    For a demonstration (and a great excuse to finally follow through), I made a drawbore pin! This is an old tool, used to test fit and align mortise and tenons using an offset peg. The idea, is if you drill a hole for the peg through the mortise with a brad point or auger bit (with a lead...
  2. froglips

    Yup, more Online Users updates.....

    These are minor. First, I must apologize and retract my statements about "Buddies" being the new name for "Contacts". I was wrong. So, when speaking to friends, family and stuffed animals please use the term "Contacts". Here is the "Contacts" page where you can view/manage your Contacts...
  3. A

    Yup, torsion boxes are strong!!

    If you didn't already know, torsion boxes are very strong and in the case of the one I just built, extremely light too!!! I built the 8' long X 3" thick X 14" wide torsion box below for the article I am working on. I made it from very thin, 1/8" Masonite hardboard, some even weaker thin peg...
  4. A

    Backbench Update- yup, w/pics*

    Well between errands, movies, etc. I got some time in the shop. Though I didn't get as much done as I had hoped, I still made some observable progress on the upper cabinets. Here are the three upper units sitting side by side on the lower cabinets. I went ahead and stained the oak faceframe and...
  5. A

    I hear ya knockin' *Yup, more door pics*

    Well I got a lot done on the door over- I finished the back side muntin grid. This grid is removable so I can remove the glass. The grid holds the glass in place and the grid is held in place with 4 SS oval head screws counter sunk slightly into the inside edge of the grid and screwed into the...
  6. A

    Yup, New Planer planes!!!

    I got the new 15" Delta planer pretty much cleaned up (gooey oil vs cosmoline) and put together (I used my I-beam hoist again to lift it onto the stand. ) I still have to do a little fine alignment of the infeed/outfeed roller tables but a test cut seemed to go ok. I still need to mount the...

Our Sponsors

LATEST FOR SALE LISTINGS

Top