speed

  1. W

    PC 7518 Router Speed Control - Help

    I just bought a used PC7518 router for table use. The speed control works fine at all other speed settings except the lowest setting- 10,000 rpm. At this setting, the router speed goes up and down and is not steady. What could be the cause of this? May be the brushes? :-x Thanks for any inputs...
  2. S

    need cheap low speed motor

    .
  3. Terry

    New shop on full speed ahead

    Hi everyone, Sorry I have not been online lately, but have been very sick. I am doing a little better but have some good news. I have purchased a 20'x20' Handi-House for my new workshop. The unit will be here next week and I will get it set up if my health holds the way I have always dreamed...
  4. M

    Lathe speed

    I am new to turning, and my work would require me to sometimes use recycled wood. Previously, I turned a few ballisters to repair a rail on someone elses lathe. I didn't kill myself, by way of common sense or probably luck. According to my training (rotational moments of inertia blah blah), I...
  5. hpetty

    Clock that runs at 1/4 speed

    Somewhat OT for woodworking, but... I have Ben Franklin clock for which I need a new movement - electric is okay. A Ben Franklin clock only has one hand and it makes one revolution every four hours. The dial is split into four quadrants with each section representing one hour in time and those...
  6. mshel

    Just got high speed internet so watch out

    Finally got rid of the dial up internet and had roadrunner installed. Its like being used to driving a vw and then hopping into a porche and flooring it. Man I really like this. Look out chat room now. LOL :bigcool:

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top