Hello All,
I just finished entering one of my pieces for the 2016 Veneer Tech Craftsman’s Challenge. It is a Tilt Top Table 30W x 30H x 30D. It contains 20,400 pieces in the design. The three main veneers used were mahogany, fumed eucalyptus, and bloodwood. The edging was quartered sapele and the stringing was made with maple and dyed black veneer. The stand was made using stitch-n-glue method on 1/4” MDF, to create the final shape before veneering. That’s one down and two more to go.
I just finished entering one of my pieces for the 2016 Veneer Tech Craftsman’s Challenge. It is a Tilt Top Table 30W x 30H x 30D. It contains 20,400 pieces in the design. The three main veneers used were mahogany, fumed eucalyptus, and bloodwood. The edging was quartered sapele and the stringing was made with maple and dyed black veneer. The stand was made using stitch-n-glue method on 1/4” MDF, to create the final shape before veneering. That’s one down and two more to go.