I'm installing the Riser Block on my new Delta Bandsaw (I already posted a gloat, so this shouldn't count as double dipping :lol: ) and run into a slight problem.
The power cord won't reach the motor. The instructions show you how to route the power cord when installing the block, but it still doesn't reach. Anyone else out there had that problem. I can drill new holes in the upright and move the switch down... but that would put two exposed holes in my shiny new Bandsaw (okay that does count as another gloat :lol: :lol: ). My other option is to contact Delta and see if they have a longer cord that they can send. Anyone have any other suggestions?
The power cord won't reach the motor. The instructions show you how to route the power cord when installing the block, but it still doesn't reach. Anyone else out there had that problem. I can drill new holes in the upright and move the switch down... but that would put two exposed holes in my shiny new Bandsaw (okay that does count as another gloat :lol: :lol: ). My other option is to contact Delta and see if they have a longer cord that they can send. Anyone have any other suggestions?