installed

  1. MarkE

    The switch on my DC is kaput (DIY remote installed)

    Went to turn on my Oneida DC this morning and got nothing. I opened up the switch box and found several melted wires. Took a quick trip to Lowes and picked up a 30 amp DPST switch and wired it in. Got the DC working again with that temporary fix. I can get a new magnetic switch from Grizzly...
  2. mbolt512

    Finished and installed!

    View image in gallery Just finished and installed the weapon/storage cabinet for our new Dojo in Lincolnton. Built from walnut and leftover materials. The only items purchased for this project was two piano hinges and two pieces of pegboard. The outside materials are walnut, alder plywood and...
  3. Bas

    Cyclone installed!

    A while back, I bought a new cyclone dust collector. Due to circumstances beyond my control (stupidity), I bought a machine that was too tall to fit in the shop! Oops. So I cut a hole in the ceiling. As always, things are never easy. The joists were positioned in such a way that there was only...
  4. Jon

    ceiling mount Excalibur blade gaurd Now Installed.

    Does anyone have the ceiling mount dust gaurd from Excalibur? EDIT: I knew a man who bought this and decided it would not work in his Basement. So he offered it to me. I went and picked it up this morning and got it installed. It raises up enough to be out of the way. I am going to get some...
  5. bluthart

    Bench Progress - Vise Installed

    Here is the Rockler 9" quick release vise I installed Monday. I set up a jig so I could router the recess easily. I then attached the vise, and cut and installed the jaws... With the jaws... just need to add tung oil.
  6. TracyP

    Donation Barometer Installed

    If you look on the Home page of North Carolina Woodworker you will now see a donation goal barometer. After discussions in several threads the Board of Directors put it to a vote. It was approved and has been installed. It is viewable just under the upper navigation bar and above the upcoming...
  7. PChristy

    Finally installed

    Tom (thrt15nc) sent me this fake drawer front hardware a few weeks ago - Thanks Tom :icon_thum I finally got it installed after I :BangHead: my head a couple of times trying to figure out how it all worked
  8. WoodWrangler

    Bandsaw Upgrade! Riser Block Installed

    This post is a little late, in relation to when I did it, but it's a GLOAT at any measure! My Grizzly bandsaw underwent a neck-lift with the riser block upgrade ... adding 6" cutting capacity! :eusa_danc The bad ... when I first installed it, I also put on a new blade. Not being that familiar...
  9. hpetty

    Anyone Installed a Riser Block on a Delta Bandsaw?

    I'm installing the Riser Block on my new Delta Bandsaw (I already posted a gloat, so this shouldn't count as double dipping :lol: ) and run into a slight problem. The power cord won't reach the motor. The instructions show you how to route the power cord when installing the block, but it still...
  10. woodguy1975

    Oak Kitchen Installed!!!

    Well after 2 months of waiting for the builder to catch up with me the kitchen is finally complete. Some of you saw some of the components in my shop when you came over for the gathering back in October. Just a little late here, but not at my fault. :lol: :lol: The update is on the main hobby...
  11. Steve D

    Riser block installed

    Well I got the riser block installed on my BS tonight. I can tell you from experience that as a one person job, you are exactly one arm short. I did manage to pull it off without any of the death, dismemberment, bodily injury or loss of property the instruction manual warns about. :mrgreen:

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top