flex
-
S
2 1/2in Flex Form Hose Kit _Rockler Sale
http://www.rockler.com/product.cfm?page=22150&filter=Rockler%20Outlet I use this on my Drill Press, works great! Free ship if you spend $75 or more..... til 29th? I think M- Splint Eastwood
- Thread
- 1 or 2in flex form hose kit rockler sale
- Replies: 1
- Forum: Found for Sale/Hot Deals
-
Rigid flex vacuum attachment
I got one of these little jewels from WoodCraft to try to improve how I use my vacuum as a DC. They have a new one that comes with two attachments for only $20. Here it is set up for power carving: Here it is at the lathe: It does not suck in all the chips when turning, but does a...- CarvedTones
- Thread
- flex rigid vacuum
- Replies: 6
- Forum: General Woodworking
-
Suggestions for flex shaft carver
Hi Y'all, I had a rotary tool (non dremel) with a flex shaft that came in a kit from Northern Tools. The flex shaft sheath burned in to. Northern does not offer any replacement parts and it would probably cost more than what I paid for the whole kit anyway. My question is does anyone use a flex...- steviegwood
- Thread
- carver flex shaft suggestions
- Replies: 11
- Forum: Woodcarving
-
Flex hose 4 inch?
Where can I get some of that flexible vacuum hose like kinda cheap? I think I need about 8 feet or so, could be 4 inch or even 3 inch. Somebody has some 4 inch PVC pipe for me but it maybe a while before I can get it.- Mike Davis
- Thread
- flex hose inch
- Replies: 15
- Forum: General Woodworking
-
6" flex piping
Anyone have an idea where I can get a small piece of 6" hose to connect my cyclone to my collection bin? I can get it in either 5' or 10' lengths, but I hate to buy that much to get a small 6-8" piece out of it. I am using 6" drops with short sections of 4" hose into the various machines. Anybody??- meika123
- Thread
- flex piping
- Replies: 6
- Forum: Workshop Discussion
-
H
Craftsman 10" Flex drive Table Saw
Someone is selling a Craftsman 10" Flex drive Table Saw for $75 is it worth it? What is Flex drive and problems associated with it?- hkj
- Thread
- craftsman 10 drive flex table
- Replies: 4
- Forum: Power Tools and Their Use
-
J
Fenner Flex Drive Belts
Back in the summer, I bought an older Delta model 10 contractor's saw. First I was thinking of using it as a parts saw, but after cleaning it up, I realized that it would be OK. Replaced the bearings on the arbor over the weekend. Put a new Goodyear Power Flex belt on saw. Saw viberated so bad...
