application

  1. kooshball

    Color and clear shellac order of application question

    I am getting dangerously close to the end of my wide dresser project and have laid down the first coat of platina shellac to seal everything off. I also plan to add 1-2 coats of orange shellac for some warming effect but I need to know if I can then top-coat that with the platina for depth...
    • kooshball
    • Thread
    • application clear color order question shellac
    • Replies: 8
    • Forum: Finishing
  2. zapdafish

    Danish oil application question

    I finished turning a bowl and decided to finish it with Watco danish oil. I don't know if its a problem or not but it soaked up a tremendous amount of it. The weight of the bowl has increased by quite abit. Being a bowl, I figured a great way was to just pour it into the bowl and spread it...
    • zapdafish
    • Thread
    • application danish oil question
    • Replies: 10
    • Forum: Finishing
  3. oderus1671

    thinning contact cement for spray application

    Hello all, at work weve just begun spraying our contact cement and have a question about thinning contact cement. Ive been told you can thin it with toluene, and weve had good sucess doing so. we have been spraying it from a binks 2001 gun with a 2 quart pressure pot with good results, except...
  4. rick7938

    Woodworking Application for Electric Motor

    I have a nice GE 1/2-hp 1750 rpm electric motor that I am wanting to put to some good woodworking application. It has a single 1/2-inch shaft with a flat for a set-screw. How can I put this motor to good woodworking use? I can't stand having a perfectly good motor and not having it earning its...
  5. Bryan S

    Best primer for this application

    The loml wants this piece painted. Now please dont beat me up I lost the refinish-vs-paint battle :BangHead:. I lost several battles in this remodel It is at least 50 years old if not much older and I believe it may be shellac as DNA seams to be wanting to take the finish off or at least...
  6. L

    Breadboard application question

    I have planed a top for the walnut chest that is 5/8 inch which will have a breadboard attached to the outer edge. It was to be 3/4 inch thick but after a few curves I found myself with 5/8th. Now that the jointer is set up properly I could make the panel again if necessary. With 5/8th thick...
  7. J

    Waterlox Application

    For those waterlox users out there. Can you guys provide any information on how you typically apply it. I really like the finish that Steve D obtained on his cherry countertop. If someone can help me out let me know. How many coats, what formula, all that good stuff.

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top