J
jeff...
Need to get a turning blank to Nic. It's about 16" x 16" x 10' long, weighs about 1000 lbs and is just about right for a 1/2 ton pickup with an 8' bed.
Thanks
Thanks
Need to get a turning blank to Nic. It's about 16" x 16" x 10' long,
Custom Toothpicks. But only 2
What are you turning? Or is it going to be a pen, and you prefer to start off with slightly thicker stock to ensure you can get to consistent dimensions while turning? Texan mallet?
:twitcy:
ok sure I'll break it down some - Can you take two blanks, 16" wide by 8" thick and 10' long, weighing about 500 lbs each?
This may make it a little more tricky for one of our kind NCWoodworker members to unload, since I doubt both will slide out together. Can he/she tie a rope to your garage door handle and the other end to the blanks and drive out underneath the blanks?
Thanks
:no:Getting close though. Do I hear 4-16" x 8" x 5' and 200 LBS each:tinysmile_tongue_t:ok sure I'll break it down some - Can you take two blanks, 16" wide by 8" thick and 10' long, weighing about 500 lbs each?
This may make it a little more tricky for one of our kind NCWoodworker members to unload, since I doubt both will slide out together. Can he/she tie a rope to your garage door handle and the other end to the blanks and drive out underneath the blanks?
Thanks
:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_dancNow that sounds more like it. I am ready to get those on the lathe:eusa_danc:eusa_danc:eusa_danc:eusa_danc:eusa_danc:icon_thum:icon_thum:icon_thum:icon_thum:notworthy::notworthy::notworthy::3dblob3:Can you take a few ~ 16" sq by 6" thick (12 BF) around 60lbs each? That'll give you around 16" round thing - were talking nice Frisbees now