My new router table is complete and already making sawdust.:eusa_clap
Only had to buy hardware and ply for drawer bottoms. Everything else was "excess" material lying around shop.
Fence and Rockler plate. The fence has sliding front to close up around the bit and will be easily replaced when needed. The fence is all MDF except the ends that attached to the T-Track.
Fence attached to T-Tracks in table edges.
4 bit drawers , router compartment and 2 misc drawers.
Specs:
Top is 32" x 28"; Cabinet height is 36 7/8"; cabinet box is 24" x 24"; 4 bit drawers will hold a max of 120 - 1/2" bit and 34 - 1/4" bits; 2 misc drawers for box set bits etc.; center of plate is 9" from front edge of table; 4" overhang on sides and 1 1/2" front and back.
Fence can be turned around and used on the front side of the plate when routing larger items on the back side of the plate. More photos in gallery.
I used the table today after I finished it to make a couple of paper towel holders and it really works good. I wish I had made it two years ago. Someone in an earlier post asked about RT heights. I am 5'11" and I don't have to bend over at all to use this table.
Only had to buy hardware and ply for drawer bottoms. Everything else was "excess" material lying around shop.
Fence and Rockler plate. The fence has sliding front to close up around the bit and will be easily replaced when needed. The fence is all MDF except the ends that attached to the T-Track.
Fence attached to T-Tracks in table edges.
4 bit drawers , router compartment and 2 misc drawers.
Specs:
Top is 32" x 28"; Cabinet height is 36 7/8"; cabinet box is 24" x 24"; 4 bit drawers will hold a max of 120 - 1/2" bit and 34 - 1/4" bits; 2 misc drawers for box set bits etc.; center of plate is 9" from front edge of table; 4" overhang on sides and 1 1/2" front and back.
Fence can be turned around and used on the front side of the plate when routing larger items on the back side of the plate. More photos in gallery.
I used the table today after I finished it to make a couple of paper towel holders and it really works good. I wish I had made it two years ago. Someone in an earlier post asked about RT heights. I am 5'11" and I don't have to bend over at all to use this table.