Got everything done that I planned to do-
Had the leftover plywood from the previous top so it fit in the well.... waste not....
Everything in my shop is on wheels and finally found some that supposedly can handle 800#. So far they are pretty nice and it's easy to move this thing around now.
Never had a tail vise , not sure how much I would use it, so thought I might try this little one from veritas.
Kept my sliding sharpening station- not pretty but it works....
Now to figure out where to put some dog holes and configure a deadman.
Maybe it's never actually completely DONE!
Had the leftover plywood from the previous top so it fit in the well.... waste not....
Everything in my shop is on wheels and finally found some that supposedly can handle 800#. So far they are pretty nice and it's easy to move this thing around now.
Never had a tail vise , not sure how much I would use it, so thought I might try this little one from veritas.
Kept my sliding sharpening station- not pretty but it works....
Now to figure out where to put some dog holes and configure a deadman.
Maybe it's never actually completely DONE!