Since I'm mounting hardware at the moment, I thought I'd share my experience with this jig. This is on Amazon for $17.99 and is the cheapest I found. I figured that with 4 drawer heights, 6 door sizes and 3 pull sizes this would be cheaper than making a bunch of shop made jigs for drilling mounting holes. And it is...rThe ruler' just like Kreg markings are unreadable until the used applies some Wite-Out to the markings. Turns out that was a waste of time since the scale is OFF! But it's easy enough to transfer the setting with an accurate ruler. In use, I simply used the jig to make starter holes, removed the jig and finished drilling the holes. Here's what it looks like in use.