fix

  1. DaveO

    Got my turning fix...

    I was unable to go to the Turning Symposium today because I just had too much to do. But I did at least get my turning fix, and almost completed one of the many things that I have to get done this month. My cousin saw some of my pens and asked if I could make him a few for his wedding in a few...
  2. Canuck

    Door Clearance Fix????

    Well.... Here we go again! I think that I bit off more than I can chew tryin' to build a DT jig storage box. Of course I just had to use inspiration from Monty and DaveO. I should have known that I am too much of a newbie to try and build something designed by those two excellent...
  3. JRD

    Got My Fix

    Steve, Thanks for ALL you do. Now that the site is back, at least partially, that's a good thing. Do you realize I had to go an entire weekend without a "Woodworker.net" fix. That's not easy for a wood addict! Jim
  4. DaveO

    How do I fix this @#&*% mistake

    I have been making a table based on this design out of QSWO. This is how far I have got. My mistake was made when I cut out the drawer opening and got a little overzealous on it's height. I don't think that I left enough on the bottom of the apron to cut out the decorative detail on...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top