Discovered another goof (this thread) with the entertainment center last night when glueing on the face frame. The bottem is about 1/16 wider than the middle and the top
It's dificult to notice in the above pic but it is like this exagerated for clarity
The problem is the bottem section will be a drawer I had planed on insetting so it is flush with the face frames and will prolly become very obvious when the drawer is installed. All 3 dados were routed out at the same time with no changes in router depth so sometthing must have moved:BangHead:. the dado for the bottem panel is not as deep as the other 2.
Possible fixes?
1- Cut out bottem panel, rout new dados and install new panel. Dont want to go through all that work but it could be done.
2- Cut off side face frames and cut new face frames oversize to compensate for gaps between frame and drawer. Not too much extra work but opens up the possibility for more goofs that will have to be fixed.
3- Just redesign the drawer to overlap (Ithink I'm saying this right) the face frames thus covering up the fopa and go with bottem mounted drawer slides insted of side mounted full extenion slides (because of the angle). Sounds like the simplest solution.
Wht ya think? Any other suggestions
It's dificult to notice in the above pic but it is like this exagerated for clarity
The problem is the bottem section will be a drawer I had planed on insetting so it is flush with the face frames and will prolly become very obvious when the drawer is installed. All 3 dados were routed out at the same time with no changes in router depth so sometthing must have moved:BangHead:. the dado for the bottem panel is not as deep as the other 2.
Possible fixes?
1- Cut out bottem panel, rout new dados and install new panel. Dont want to go through all that work but it could be done.
2- Cut off side face frames and cut new face frames oversize to compensate for gaps between frame and drawer. Not too much extra work but opens up the possibility for more goofs that will have to be fixed.
3- Just redesign the drawer to overlap (Ithink I'm saying this right) the face frames thus covering up the fopa and go with bottem mounted drawer slides insted of side mounted full extenion slides (because of the angle). Sounds like the simplest solution.
Wht ya think? Any other suggestions