Hi,
I am new to this site and this is the first topic I thought I might post about and get some help. I recently purchased a Vega Duplicator for my lathe and was wondering if there are any users of these duplicators on this forum and if I could get some tips and advise as the directions seem a little lite... I have it mounted on a General 260 with riser and have it aligned and have turned some basic dowels in sizes from 1 1/4 inch down to 1/4 inch. Now it is time to move on to making some more useful turnings...
Best,
Todd
I am new to this site and this is the first topic I thought I might post about and get some help. I recently purchased a Vega Duplicator for my lathe and was wondering if there are any users of these duplicators on this forum and if I could get some tips and advise as the directions seem a little lite... I have it mounted on a General 260 with riser and have it aligned and have turned some basic dowels in sizes from 1 1/4 inch down to 1/4 inch. Now it is time to move on to making some more useful turnings...
Best,
Todd