The site tells me it's been awhile since I've posted so I wanted to show what I've been up to.
Since I saw this post http://ncwoodworker.net/forums/showthread.php?p=9313#poststop (notice the dual miter slot). I got to thinking about upgrading my table saw (since I did not see a nice new one in my immediate future) . Well I finally am almost finished with the upgrades and its time to show.
And since I was using sawhorses with ply for my assembly bench I went ahead and buit this to match.
Now if I could only find some 1 inch self adhesive measuring tape, I would be set to go. I should be able to cut 64 in. to the right of the blade now.
Also have the makings for a new entertainment center up on the bench, but need about 100bf of red oak to complete (heh such is life)
Since I saw this post http://ncwoodworker.net/forums/showthread.php?p=9313#poststop (notice the dual miter slot). I got to thinking about upgrading my table saw (since I did not see a nice new one in my immediate future) . Well I finally am almost finished with the upgrades and its time to show.
And since I was using sawhorses with ply for my assembly bench I went ahead and buit this to match.
Now if I could only find some 1 inch self adhesive measuring tape, I would be set to go. I should be able to cut 64 in. to the right of the blade now.
Also have the makings for a new entertainment center up on the bench, but need about 100bf of red oak to complete (heh such is life)