When I put the riser block on Mike Davis/Roberts Saw, it came with a conversion kit that fit it for a Jet Saw, except the Guide support on a Jet Saw is round with groove to keep it from spinning. The Guide for this saw is Hexagonal.... similiar to the old Craftsman saws.
no problem for me 1/2 hour later with the aid of a bench grinder I fit a round peg in a hexagonal hole:widea:
but in lieu of yesterdays band saw blues post, I have decided to get a new set of roller bearings. I figure in for a penny in for a pound. Does anybody know where I can get a hexagonal Guide support for a REASONABLE price?
Dan
no problem for me 1/2 hour later with the aid of a bench grinder I fit a round peg in a hexagonal hole:widea:
but in lieu of yesterdays band saw blues post, I have decided to get a new set of roller bearings. I figure in for a penny in for a pound. Does anybody know where I can get a hexagonal Guide support for a REASONABLE price?
Dan
