Make sure you let us know how you like it when you receive it. One test to check table alignment is clamping a thick board to the sliding table as if you are going to straight line rip it, something like a flat 2x6 or 2x8. Clamp it to the sliding table and ensure it doesn't bind on the cast iron table. Most people make measurements right near the blade, but the 79" sliding table can sag/flex a bit and boards can bind on the front or rear parts of the cast iron table. This is most noticeable when clamping boards down, because the clamps don't allow things to move.
We really should try and have a Sliding Table Saw Workshop at some point where we can talk about some techniques, jigs and setups. Maybe sometime this Summer.