Corner cupboard--door #2 dry fitted

Status
Not open for further replies.

JimReed2160

New User
jim
Another hour in the shop means a chance to trim panel #2 and dry fit it in the door. The LN #62 plane did a masterful job at raising the panel and also trimming all the sides to fit. Now both doors are dry fitted. Here is the money shot of them in place.

IMAG0087.jpg


Next job is to put finish on the pieces and then glue up the mortices and tenons. I am planning some red stain for the walnut, BLO for the maple, and poly for both. Finishing might be easier if I do some of it before glue up.
 

JimReed2160

New User
jim
It is nice to see it moving along. I started in 2004 & picked back up last summer. Once I finish the bottom, it will be too hot to work much in the shop, so it may be some time before I start on the top piece.
 
Status
Not open for further replies.

Premier Sponsor

Our Sponsors

Top