ports

  1. kooshball

    6" Dust Ports??

    Was anyone running 6" duct able to find a good source for 6" dust ports or did you have to fabricate your own?
  2. dino drosas

    2 Festool Systainer Ports

    These are currently listed on Ebay and ARE mine. They are in like new condition. It is quite rare to find these for sale other than by a dealer at 575.00 each. They are in Myrtle Beach but it is possible that I could meet a buyer part way...
  3. dino drosas

    2 Festool Systainer Ports

    These are currently listed on Ebay and ARE mine. They are in like new condition. It is quite rare to find these for sale other than by a dealer at 575.00 each. They are in Myrtle Beach but it is possible that I could meet a buyer part way...
  4. 6'' Dust Port - 04 Tablesaw Install

    6'' Dust Port - 04 Tablesaw Install

    Port installed with four 1'' sheet metal screws -- I'll paint it Grizzly Green!
  5. 6'' Dust Port - 03 Tablesaw Install

    6'' Dust Port - 03 Tablesaw Install

    Hole sawn out -- 12 Gauge metal in Grizzly Cabinet!
  6. 6'' Dust Port - 02 Tablesaw Install

    6'' Dust Port - 02 Tablesaw Install

    I drilled small hole from inside of saw just above dust partition in line with blade, then made hole 1/2'' to allow saber saw blade to fit. Circle draw with Sharpie inside coupling.
  7. 6'' Dust Port - 01 My Version

    6'' Dust Port - 01 My Version

    I cut 6'' PVC Coupling in half on my tablesaw (3/8'' deep cut against fence - left 3 small ''bridges'' to keep together and cut by hand); glued each half into 3/4'' Baltic Birch plate with clearance hole using Gorilla Glue.

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top