fault

It's Roy's Fault

After watching the Woodwright's Shop episode on the Elizabethan-joint stool, I decided to give it a try. Ended up with this: The week of Thanksgiving, I split out an oak log (tree dropped in Sept) with maul, axe, and wedges to get some segments that looked like this: Then took the froe I...
- Gofor
- Thread
- Jan 19, 2012
- fault roy
- Replies: 16
- Forum: General Woodworking
Its Charlie's Fault

A couple weeks ago I ran into Charlie going into Klingspor's. That progressed to a tour of his Awesome shop!, but he also gave me a few pieces of purple heart, which I had not used before. It appeared to be a good hard dense wood, and I have been looking for something to make a shooting plane...
- Gofor
- Thread
- Jun 11, 2010
- charlie fault
- Replies: 9
- Forum: Hand Tools and their Use
New Nova DVR XP getting Fault Low Voltage

Without starting a flame I would like to ask one question. Do others have the Fault LowVoltage warning on very light catches? Mine is only 4 days old and has the latest version board according to Tim 6.06xs14 which is not suppose to have these errors anymore. I can't turn a bowl without...
- mountaintop
- Thread
- Oct 30, 2009
- dvr fault low nova voltage
- Replies: 9
- Forum: Woodturning
arc fault circuit breakers

All, I'm in the midst of wiring my new shop, and I wonder if anyone has had either good or bad experiences using arc fault circuit breakers. I don't think that they're required in my application, but I'd thought about using them for the added measure of safety. However, somewhere I read that...
- brenthenze
- Thread
- Jan 2, 2009
- arc breakers circuit fault
- Replies: 14
- Forum: Workshop Discussion
It's DaveO's fault

I was sanding along a few weeks ago, and all of a sudden my RAO sander decides to die.:tinysmile_cry_t: Ok well I have had it for a while, so I gave it a burial and laid it to rest. ( I threw in the trash) That evening I am reading one of my new woodworking rags and low and below they have...
- skysharks
- Thread
- Aug 26, 2008
- daveo fault
- Replies: 9
- Forum: Power Tools and Their Use
It wasn't all my fault! Dovetail saw tuneup

Well, the Crown 10" Dovetail saw arrived and initially everything was good, but practise and the real thing are two different animals. Over this weekend I have cut about 50 dovetails and to be perfectly honest, although they were getting better I was not happy with any of them. When I looked at...
- DavidF
- Thread
- Jan 7, 2008
- dovetail fault tuneup
- Replies: 19
- Forum: Hand Tools and their Use