answer

I know somebody can answer this

The wife and I went to Cameron yesterday and browsed through the antique shops. I always look at the joinery used on some of the old furniture. I'm amazed at the fine work on some of the obviously hand cut joints. I was looking at an old desk and ran across this. It's just so interesting...
- Bugle
- Thread
- Feb 19, 2011
- answer
- Replies: 3
- Forum: General Woodworking
RC's answer the FK's 3 min DT

Franks was fast but not so good looking. Rob's is something else . . . http://blogs.popularwoodworking.com/editorsblog/Rob+Cosmans+312+Minute+Dovetails.aspx pete
- PeteM
- Thread
- Oct 30, 2008
- answer min
- Replies: 32
- Forum: Hand Tools and their Use
Need a "straight" answer

I'm needing a 24" straight edge (minimum length) for precision alignment of the fret board and frets on my guitar. Woodcraft sells the Pinnacle 24" unit for $90.00. ($190.00 for 48") I've seen other brands for more and some for less.... Not ever using one of these "high precision edges" I...
- JohnW
- Thread
- May 25, 2007
- answer straight
- Replies: 3
- Forum: General Woodworking
Quick answer needed????

I have a 11.75" piece of curly maple, most of the curl is on the outer edges. The box I am currently working on needs a 8" lid. Should I rip it down the middle a glue the 2 halves back together or just trim off one edge to get my 8" width. I am gonna do something tonight so hope y'all are paying...
- DaveO
- Thread
- Feb 13, 2006
- answer needed quick
- Replies: 15
- Forum: General Woodworking