Woodpeckers Hole boring jig follow up

[Strom]

Got it done. Looking forward to using this much improved outfeed table.
I have a Festool 1080 MFT that is now redundant.
My experience with this jig overall was good. I have not checked the hole pattern for dead square yet.
My biggest recommendation is to get a good quality solid carbide upcut bit.

 

[Mike Wilkins]

Looks great. I got the 20 millimeter jig so I could use the Festool accessories. My first table was made using some el-cheapo plywood from the big blue store and a straight bit. I have since purchased a spiral uncut bit and will be making it on some MDF so I can be like the big boys at Festool.
Tight clamping is a must.

 

[Strom]

Same . these are 20 mm.