J
jeff...
I need to replace my router table top it's two glued up pieces of 3/4" birch plywood skim coated with plastic resin (bondo) and sanded flat and smooth to a high gloss finish. Wood is pretty abrasive and it has not held up as well as I would have hoped. The insert is a 1/2 clear polycarbonate plate with several leveling screws.
What I would really like is a better fence system with a few tee slots for stop blocks and feather boards. I would also like a couple of tee slots in the top for a miter gauge, feather boards and setup. It would also be cool if I could mount another router horizontally to the front of the top that I could tilt and be able to run both routers at the same time that way I could really mess up some wood.
What's a good material for table and fence or would I be better off buying one and putting it on my stand.
I'm way open to design and material ideas.
Thanks
What I would really like is a better fence system with a few tee slots for stop blocks and feather boards. I would also like a couple of tee slots in the top for a miter gauge, feather boards and setup. It would also be cool if I could mount another router horizontally to the front of the top that I could tilt and be able to run both routers at the same time that way I could really mess up some wood.
What's a good material for table and fence or would I be better off buying one and putting it on my stand.
I'm way open to design and material ideas.
Thanks