Have you used more than a single ten inch blade on your table saw rather than a dado set?
I want to do another Celtic knot, that is much thicker than a single blade, in a three inch block.
My dado set does not have the height. And, I'm having alignment issues using spacers, among glue up,
and thin kerf blade. A complete mess, but a tap pull was promised. Just want it to memorable for the recipient.
I want to do another Celtic knot, that is much thicker than a single blade, in a three inch block.
My dado set does not have the height. And, I'm having alignment issues using spacers, among glue up,
and thin kerf blade. A complete mess, but a tap pull was promised. Just want it to memorable for the recipient.