molding saw

[Glennbear]

I was thinking about making some trim for the shop walls once I have it set up but then I noticed this saw on CL and thought it might be better for trim work. Any input as to whether it could handle 1x2 moldings etc? :eusa_thinhttp://raleigh.craigslist.org/tls/653774079.html

 

[ptt49er]

I think you might be straining that saw a little too much...

But I don't do any work that heavy, so you buy that and I'll trade you for my old CM saw ;-)

 

[Tarhead]

I'm thinking it would be a stretch but if you took your time it should handle very small pieces of pine. Their 12hp model would be ok.:rotflm:

 

[Mike Davis]

How do you even use a saw like that?

I'd need an interpreter to read the directions. :no:

 

[nelsone]

Glenn, I'm sure that's just pocket change for you so go ahead and see if it works. If not you can always toss it to the curb (call me when you are ready to toss it to the curb and I will gladly tell you where my curb is located!)

:rotflm:

 

[JimmyC]

That saw should fit just fine in the new addition that you'll need to build onto your shop.:rotflm:

Jimmy