May I use your disk sander for a small job?

[kelLOGg]

I have 2 arced pieces of ash and I need to sand one edge of each to make it perpendicular to the face. The pieces measure 2" thick, 2' wide and the arc is about 4 ft long. I think a disk sander would be ideal for this. So, if you have one and are willing for me to come over to use it for a few minutes I would like a response from you. I am in Durham and am willing to go about 25 miles. See pic.

 

[Charlie]

Bob,
I am located S. Raleigh and have a 20" disc sander with 100 grit paper you are welcome to use.
I also have a spindle sander up to 3" dia. for the inside.
If you would like to come over please give me a call @ 919-744 1444.

 

[FredP]

I'm in franklinton if you don't find someone closer.

 

[tvrgeek]

In Hillsborough if easier.

 

[kelLOGg]

Thanks for the additional offers. I just got back from Charlie's who did the job post haste and gave me a tour of his incredible shop and his segmented turnings. They were amazing as was our conversation - a really nice guy. The best of NCWW continues!!!