A while back i got a 12" Jet disc sander and picked up some 12" replacement discs at Woodcraft for future changes.
The original disc worked great, but I am having a problem with the replacements staying stuck flat on the metal disc.
I have cleaned the bejugies out of the disc surface and had no trouble getting the new disc centered and plastered flat. But the outer 3/4" or so keeps buckling up. I have burnished the disc back flat by running some oak against the spinning disc to the point of heating it up in hopes it would activate the adhesive better....it stays flat for a few hours and then re-buckles...I have even used a heat gun to try make it stick better...no dice.
I am on my third replacement disc with the same problem.
I am hoping I just have just some bad discs.
Anyone have any ideas for more successful adhesion?....Where do you get your discs?
The original disc worked great, but I am having a problem with the replacements staying stuck flat on the metal disc.
I have cleaned the bejugies out of the disc surface and had no trouble getting the new disc centered and plastered flat. But the outer 3/4" or so keeps buckling up. I have burnished the disc back flat by running some oak against the spinning disc to the point of heating it up in hopes it would activate the adhesive better....it stays flat for a few hours and then re-buckles...I have even used a heat gun to try make it stick better...no dice.
I am on my third replacement disc with the same problem.
I am hoping I just have just some bad discs.
Anyone have any ideas for more successful adhesion?....Where do you get your discs?