I purchased some templates to do an inlay on a table. I also got the guide and router bit for the inlay.
I cut out the design with the 1/8 spiral bit and wasn't sure how to clean out the cut out. I assumed not to try that with an 1/8th bit and guessed you would use a larger bit and do it by sight.
Any info would be helpful as I think cleaning the cut out with a larger bit with a guide would be hard to control.
I cut out the design with the 1/8 spiral bit and wasn't sure how to clean out the cut out. I assumed not to try that with an 1/8th bit and guessed you would use a larger bit and do it by sight.
Any info would be helpful as I think cleaning the cut out with a larger bit with a guide would be hard to control.