As no corner is 45 degrees, using the compound is hit or miss. I looked at the popular jigs and found them to be lacking, so a bit of angle iron and I made my own.
I made setup blocks for the two size moldings in my house. As I only have to do the miter, I can do the 45.7 degree or whatever and the bevel is not off.
It is not dissimilar to the flimsy sheet metal DeWalt jig. My Ridgid actually has a tapped hole in a reinforced boss on the side already.
I made setup blocks for the two size moldings in my house. As I only have to do the miter, I can do the 45.7 degree or whatever and the bevel is not off.
It is not dissimilar to the flimsy sheet metal DeWalt jig. My Ridgid actually has a tapped hole in a reinforced boss on the side already.