Please let me know if anyone on the forum in interested before I post this elsewhere...
1/2 HP motor, no belt guard, the belt seems to be in good condition, but it is old so if I were going to put this back in action, I would replace it.
6" wide bed with rabbet step by 32" long. (see the pictures below)
Obviously the bed and fence need attention and a little TLC. I believe there is no pitting, just surface rust on the working faces.
The fence lock (handle / nut) is the style I really like where you can open the fence beyond 90 degrees, IIRC, it open to 15 or 20 degrees past vertical (see the picture below)
Someone prior to me painted over some pitting on / in some of the "non-working areas" on the fence etc. I had plans, but...
I plan to be in the Greensboro / Raleigh area on the 8th or 9th, if distance is a concern and we can figure out where to meet (likely after 5:00 on a given day)
1/2 HP motor, no belt guard, the belt seems to be in good condition, but it is old so if I were going to put this back in action, I would replace it.
6" wide bed with rabbet step by 32" long. (see the pictures below)
Obviously the bed and fence need attention and a little TLC. I believe there is no pitting, just surface rust on the working faces.
The fence lock (handle / nut) is the style I really like where you can open the fence beyond 90 degrees, IIRC, it open to 15 or 20 degrees past vertical (see the picture below)
Someone prior to me painted over some pitting on / in some of the "non-working areas" on the fence etc. I had plans, but...
I plan to be in the Greensboro / Raleigh area on the 8th or 9th, if distance is a concern and we can figure out where to meet (likely after 5:00 on a given day)