visa

A
Glue up, then stain etc. or visa versa?

I am building a sideless end table from the designs in wood magazine. I am using cherry for the case and maple for the top. The question is, what is the proper procedure for finishing. I am using M&T joints. My concern is the corners. If I glue up first, I worry that I will get a blob of...
- AlexSwansboro
- Thread
- Dec 20, 2011
- glue stain versa visa
- Replies: 7
- Forum: Finishing
Big Visa Bill Gloat no. 1

Due to a good tax season, I made the following acquisitions: Lie Nielson low angle smoothing plane, large chisel plane and scraper. Veritas/Lee Valley no. 7 low angle jointer and scrub plane. Woodrat with Dewalt Pluge. Dewalt angled finish nailer (cordless). Festool Domino and power planer...
- Nativespec
- Thread
- May 5, 2007
- big bill gloat visa
- Replies: 14
- Forum: Workshop Discussion