threejaw
-
four- (or three-)jaw chucks for a midi-lathe?
Hi all, I picked up a Delta midi-lathe awhile back on clearance, and I'd like to add a decent chuck so that I can try doing some small bowls, goblets, etc. Any suggestions on what's a good chuck for this purpose? Anything I should watch out for? I haven't used one before, but I see that...- brenthenze
- Thread
- chucks midilathe threejaw
- Replies: 6
- Forum: Woodturning
Premier Sponsor
Our Sponsors
LATEST FOR SALE LISTINGS
-
-
-
SOLD -- $75: Gast moa v113 Vacuum Pump Veneer, 60" bag and board- Started by peterdnight
- Replies: 1
-
GONE: Gladiator 5 cleats, 10 hangers, Paper Towel and Shelf
- Started by peterdnight
- Replies: 3
-
SOLD -- $100 Makita mac700 portable air + grex pin nailer + 2 others + 50' hose
- Started by peterdnight
- Replies: 1