tablesaw

Tablesaw Router Fence

A daughter presented me with a Woodpecker QuickLift for use between the rails of my Ridgid TS3650. This created the need for a router fence to attach the the rip fence. I threw this one together on the fly. It's just a rectangular box with 4 partitions inside, 2 of them being to create the...
- Ken Massingale
- Thread
- Dec 30, 2005
- fence router tablesaw
- Replies: 13
- Forum: Power Tools and Their Use
Panel Raising Jig - Raising position

Cutting a 11 degree bevel on the front side of a door panel -- I usually do a pre-cut 1/8" deep on face to avoid chipout and to form a nicer reveal.
- McRabbet
- Media item
- Nov 16, 2005
- jig panel tablesaw
- Comments: 2
- Album: Jigs and Fixtures
Panel Raising Jig - Rear

Rear of jig with knobs to adjust runner; base is 12" wide and rides along fence for accuracy.
- McRabbet
- Media item
- Nov 16, 2005
- jig panel tablesaw
- Comments: 0
- Album: Jigs and Fixtures
Panel Raising Jig

Panel Raising Jig for my TS - adapted from a plan in Wood magazine. I'm back-cutting a panel in this view (holds up to 30" panel).
- McRabbet
- Media item
- Nov 16, 2005
- jig panel tablesaw
- Comments: 0
- Album: Jigs and Fixtures
Crosscut Sled

1/2" Baltic Birch Crosscut Sled with dual runners and Maple fences (guard to be added). That's the TS Remote Control by the tape.
- McRabbet
- Media item
- Nov 16, 2005
- crosscut tablesaw
- Comments: 0
- Album: Jigs and Fixtures