placement
-
H
Dust collection: Duct placement to TS?
I have known for a long time I need to improve my dust collection - and any system would be a big step up from a shop vac! When a friend whose dad ran a pro shop came in and the first thing she said was "Looks like you need a dust collection system" ... I pleaded guilty and resolved to change...- Henry W
- Thread
- collection duct dust placement
- Replies: 13
- Forum: Workshop Discussion
-
S
Air filtration system placement
Good evening everybody, I am about to finish my home made air filtration system and would like some input on where to place it. The measurements are 16.5" wide, 25" tall and 20" long and I have attached some pictures. I initially planed to suspend it from the ceiling using eye hooks and chain...- stoney
- Thread
- air filtration placement system
- Replies: 8
- Forum: Workshop Discussion
-
Hardware Placement
Hey Folks, I wanted to offer up some advice I have learned from trimming out furniture cases through the years. The right hardware in the right location can really set your work apart! First, after you decide on knobs or pulls, do a simple sketch with the hardware. This will help give you an...- Dutchman
- Thread
- hardware placement
- Replies: 1
- Forum: General Woodworking
-
Air filter placement??
There is a very good change that I will be getting the Jet air filter that I have had my eye on. I found a slightly used one for sale and will be checking it out today. I am wondering it anyone has any recommendations for the best placement of it in the shop for maximum efficiency. My shop is a...- DaveO
- Thread
- air placement
- Replies: 1
- Forum: Workshop Discussion
-
Proper Forum placement
Don't anyone look at this as a reprimand. That is not my intention, just a reminder for the members and perhaps some instruction for the new. The only reason, I mention this is becuase it can become important when people are looking the forums for info. The "How do I" forum is strictly for...- SteveColes
- Thread
- forum placement proper
- Replies: 3
- Forum: Staff Announcements
-
Router Placement on rotuer Table
Okay, I'm following Uncle Nohm's Router Table plans pretty closely but I've run into a question on placement of the Router Plate. The plans call for the center of the plate to be 10 3/4; from the front edge of a 24 1/2 Table. Is there any reason (other than leaving room for the fence base) to...- hpetty
- Thread
- placement rotuer router table
- Replies: 5
- Forum: Power Tools and Their Use
