omg
-
OMG, I Painted Cypress!!
But it was for a good cause. I got some cypress from Rick DiNardo this week and I put paint on it! All was not in vain though. The cypress turned into four window boxes for my storage building and my little shop. Then they turned into Christmas planters:wink_smil. This is the start of our...- TracyP
- Thread
- cypress omg painted
- Replies: 13
- Forum: General Woodworking
-
J
OMG another wood report from the BORG
err... umm... FS KD FAS / Select S4S 1x6-8 - $6.02 a BF yes you read right $6.02 a BF - OMG $24.08 for a single red oak 1x6-8 board. :swoon: On a side note - talked to two loggers last week - they are no longer cutting pine nobody wants to buy it.- jeff...
- Thread
- borg omg report wood
- Replies: 1
- Forum: Wood
-
OMG I almost lost a finger!
Wow what a crazy day! I almost got in two car wrecks & then I injured my pointer finger on the Miter saw! I'm usually very careful & aware of my surroundings! But today was just an off day, but a refreshing wake up call! I was cutting a piece of wood with my miter saw & I went to grab it two...- Ncdawgs1882
- Thread
- finger lost omg
- Replies: 19
- Forum: Safety & Health
-
G
OMG, Knot another knot
I built a new miter sled at 55 degrees and tried it with a thinner blade. I like the higher angle and thinner blade more than the 45 and standard kerf blade. This is a Gold Artisan Cigar dressed in figured Sapelle with a hard maple 4-ring knot. The pen is finished with CA, MM, and buffed out...- Gary G
- Thread
- knot omg
- Replies: 12
- Forum: Woodturning
