While checking and tuning my table saw, G1023, I measured excessive difference in the flatness of ALL my blades. Freud glue line, Freud crosscut and Forrest WW II. While rotating each blade I measured a difference of 0.009" on every blade. Way too much of a coincidence. Had already checked arbor, arbor flange and miter slot and they were good. Had cleaned off all dust and buildup. So either all my blades were off or my washer or stabilizer were bad. After removing stabilizer, all blades were within 0.003. Not bad for +7 year old blades.
Couldn't believe my stabilizer, sometimes called a stiffener, could be that far off. Just one more thing to check when tuning up your saw.
Couldn't believe my stabilizer, sometimes called a stiffener, could be that far off. Just one more thing to check when tuning up your saw.