Looking for Forstner Bit Extension

[Flute Maker]

So put three of those extensions together.

Yeah I could but be better to have just one….Having 3 could cause problems if the connections are too big…. Not being able to do the smaller sizes at all…..

 

[Flute Maker]

I think you will have to get an extension brazed to a bit.

Yes

 

[Jim Gross]

I found an 18" extension when I was drilling out foam in a jon boat for rod tubes. I do not have a link anymore but I believe I found it on Amazon. It has 2 or 3 set screws to hold your bit in the end so it should work with your round shank

 

[Flute Maker]

I found an 18" extension when I was drilling out foam in a jon boat for rod tubes. I do not have a link anymore but I believe I found it on Amazon. It has 2 or 3 set screws to hold your bit in the end so it should work with your round shank

I’ll check Amazon! Jim would it fit a Forstner bit with 3/8” on the chuck end?