Folks,
Anyone out there using a Jointech Clincher or Incra TS/Twin Linear fence?
I am contemplating on getting either the Jointech or the Incra. I like to adapt it for use on a sliding table saw to make my own solid edgebanding (3-4mm thickness). Both systems seem to be accurate and precise enough to repeatedly cut of 3-4 mm sticks. and with one path through the drum sander for final thicknessing, I hope to get the edgebanding I want. I am planning to attach a piece of aluminum extrusion (from 80/20) and hold the stock with vacuum.
From what I searched and read on the net, the jointech seems to be the better or least beefier of the two. But I have never seen one in real life and nothing beats first hand experience. Since these things are a bit pricey, I don't want to get something I"ll regret later (I already have plenty of those things!).
Any opinions, suggestions, comments are appreciated!
Bernhard
Anyone out there using a Jointech Clincher or Incra TS/Twin Linear fence?
I am contemplating on getting either the Jointech or the Incra. I like to adapt it for use on a sliding table saw to make my own solid edgebanding (3-4mm thickness). Both systems seem to be accurate and precise enough to repeatedly cut of 3-4 mm sticks. and with one path through the drum sander for final thicknessing, I hope to get the edgebanding I want. I am planning to attach a piece of aluminum extrusion (from 80/20) and hold the stock with vacuum.
From what I searched and read on the net, the jointech seems to be the better or least beefier of the two. But I have never seen one in real life and nothing beats first hand experience. Since these things are a bit pricey, I don't want to get something I"ll regret later (I already have plenty of those things!).
Any opinions, suggestions, comments are appreciated!
Bernhard