rocks

Electrolysis Rocks for Rust Removal!

I've been cleaning/derusting/restoring a contractor table saw I got from junquecol's stash, and decided to give electrolysis a try. My setup involved two anodes which are 1/2" rebar zip tied to some old brake rotors I had lying around after I helped my neighbor change his brakes. The rotors have...
- Mike Camp
- Thread
- Oct 24, 2011
- electrolysis removal rocks rust
- Replies: 5
- Forum: Power Tools and Their Use
Sometimes Simplicity Rocks!

In the past, when I needed to square and finish cut a large panel I would resort to a homemade circular saw guide and a top bearing bit my router to clean up the edge. Inevitably, it would be a bear to make sure I was on the line and square. Now I have several XCut sleds for the table saw but...
- Canuck
- Thread
- Sep 17, 2011
- rocks simplicity
- Replies: 3
- Forum: General Woodworking
Veritas Scraping plane rocks!

I'm a bit embarrassed to admit that I've had this plane for a few years any haven't used it a lot. Looking back, I thought that since planes are, in general, much more difficult to sharpen tune than card scrapers, I would need to master sharpening a card scraper before I could sharpen and use...
- merrill77
- Thread
- Jul 7, 2011
- plane rocks scraping veritas
- Replies: 8
- Forum: Hand Tools and their Use
Ncww rocks!!!

As most folks are aware NCWW had a super booth at the WW Show in Charlotte. There are even a few pics to prove it. If others have pics please post them for all to see. I met a number of members I had never met before. Talked to a bunch of potential new members. Renewed friendships with...
- ScottM
- Thread
- Mar 28, 2011
- ncww rocks
- Replies: 13
- Forum: Staff Announcements