piping

  1. T

    6" & 4" spiral pipe and fittings

    I am looking for approximately 60-80' of 6" spiral pipe and approximately 40' of 4" spiral pipe to help finish assembling my dust collection system. In addition, I will need 6x6x4" lateral y's. If you know of anyone that has some of these products would you please send them my way via email...
    • Temp626
    • Thread
    • collection collector cyclone duct ductwork dust fittings hose lateral pipe piping reducer separator shopvac spiral vacuum
    • Replies: 2
    • Forum: Where Can I Find, Buy or Sell?
  2. Splinter

    Air piping for shop

    After a recommendation by Woodguy1975 I decided to install this system in my new shop. I purchased the "Master Kit" and installed it. I was rather skeptical that the push on fitting would work without leaking air. I was wrong. They do not leak. The system is super easy to install. If you change...
  3. D

    Question on Piping

    I am in the slow process of installing a dust collector as funds are available. The DC will be going in the corner inside for now and later in another room. There is one problem I am not sure about, I plan on using thin wall white 4" pipe w/the fewest amount of flex possible. So now to my...
  4. meika123

    6" flex piping

    Anyone have an idea where I can get a small piece of 6" hose to connect my cyclone to my collection bin? I can get it in either 5' or 10' lengths, but I hate to buy that much to get a small 6-8" piece out of it. I am using 6" drops with short sections of 4" hose into the various machines. Anybody??
  5. Splinter

    DC piping?

    If a person was building a new WW'ing shop that was going to have a concrete floor (raised floor not a good option for other reasons) other than the obvious problem of future equipment relocations, is it a BAD idea to place the DC piping under the concrete? Assuming careful planning has taken...

Premier Sponsor

Our Sponsors

LATEST FOR SALE LISTINGS

Top