cl@ss

WW cl@ss - fliptop cabinet part 5: Installing the drawer, casters and supports

Fliptop cabinet part 1 Fliptop cabinet part 2 Fliptop cabinet part 3 Fliptop cabinet part 4 Nothing complicated in this part, basically finishing up the drawer and supports to get ready for trimming the edges. Installing the drawer Installing a single drawer is not that difficult...
- Bas
- Thread
- Aug 10, 2008
- cabinet casters cl@ss drawer fliptop installing part supports
- Replies: 6
- Forum: General Woodworking
WW cl@ss - fliptop cabinet part 4: Building the drawer

Fliptop cabinet part 1 Fliptop cabinet part 2 Fliptop cabinet part 3 Making the drawer parts If this is your first drawer, you may be somewhat intimidated by the use of slides. I certainly was. Before you start making the drawer, make sure you have the slides in hand. I purchased a set from...
- Bas
- Thread
- Aug 7, 2008
- building cabinet cl@ss drawer fliptop part
- Replies: 0
- Forum: General Woodworking
WW cl@ss - fliptop cabinet part 3: Building the rotating platform

Fliptop cabinet part 1 Fliptop cabinet part 2 Making the platform parts Surprisingly, building the platform is the easy part in this project. Trim the platform shelves by 1/8” down to 20 7/8”. This will give you 1/16” of clearance on either side, enough for the washers that will be used as...
- Bas
- Thread
- Aug 6, 2008
- building cabinet cl@ss fliptop part platform rotating
- Replies: 2
- Forum: General Woodworking
WW cl@ss - fliptop cabinet part 2: Building the carcass

Fliptop cabinet part 1 Note: This is cabinet making 101. If you’ve ever made a bookcase, this is pretty straightforward, but I decided to err on the side of caution and add a lot of detail. Cutting the panels and joints The first step is cutting the plywood panels to size. You...
- Bas
- Thread
- Aug 5, 2008
- building cabinet carcass cl@ss fliptop part
- Replies: 1
- Forum: General Woodworking
WW cl@ss - fliptop cabinet part 1: Measurements & Material list

Pictures of the completed stand Preamble to this WW class The measurements for this project are more of a guideline, since you will have to tailor it to your tools and preferences. See diagram 1 below. Diagram 1 I measured the width of my miter saw, added ½”, and determined the...
- Bas
- Thread
- Aug 4, 2008
- cabinet cl@ss fliptop list material measurements part
- Replies: 5
- Forum: General Woodworking