Hey, this is my first post. I need your review on a rockler router bit which i am thinking to buy and getting mix opinion on it.
I think to purchase this because it suits my work.
It is easy to machine parts using the lock miter bit, because when i set the bit height right, one part gets cut horizontally on your router table and the corresponding part gets cut vertically. This is the bit that you buy for joining cabinet parts, drawer boxes, and making four sided columns.
But i read a article on rockler router bit. And read about its pros and cons.
In cons section i read that :-
Some of the users have complained about the construction quality
You will get considerable kickbacks even when you go slowly.
So i want to confirm this happens for not. If you guys used it and having construction quality issues then please tell me. As if this doesn't happen then i ready to purchase it.
Please give your reviews - good or bad.
Thanks in advance.
I think to purchase this because it suits my work.
It is easy to machine parts using the lock miter bit, because when i set the bit height right, one part gets cut horizontally on your router table and the corresponding part gets cut vertically. This is the bit that you buy for joining cabinet parts, drawer boxes, and making four sided columns.
But i read a article on rockler router bit. And read about its pros and cons.
In cons section i read that :-
Some of the users have complained about the construction quality
You will get considerable kickbacks even when you go slowly.
So i want to confirm this happens for not. If you guys used it and having construction quality issues then please tell me. As if this doesn't happen then i ready to purchase it.
Please give your reviews - good or bad.
Thanks in advance.