Do you know if any of these places check a 10" TS blade for alignment and balance?
I had my woodworker II sharpened at Raleigh Saw about 6 months ago and it seems to make more noise when using my zero clearance insert in my TS than it did prior to sharpening. Not sure if it is not aligned or out of balance . . . or maybe it is my saw that is not quite right? Would love to figure it out. I just bought a FTG full kerf blade that I'll make another zero clearance insert for to see if I have the same issue.
I had my woodworker II sharpened at Raleigh Saw about 6 months ago and it seems to make more noise when using my zero clearance insert in my TS than it did prior to sharpening. Not sure if it is not aligned or out of balance . . . or maybe it is my saw that is not quite right? Would love to figure it out. I just bought a FTG full kerf blade that I'll make another zero clearance insert for to see if I have the same issue.