I started working on my Leigh Dt jig storage box last night, with panel glue-ups. Today between my activities this morning - handing off my old TS, and child-care duties this evening while the wife went out to an X-mas party. I finally got all the boards cut to size, cut the DTs, glues, clamped, rabbeted for the back and installed the back, and sanded. Here it is with a quick MS wipe down.
Tomorrow, I will make the drawer that goes under the shelf, and the doors.
:eusa_thin I do have a question for ya'll, I had thought I would go with two inset doors, but now I am not sure that would be the best way. I don't want to do a sliding door, 'cause Insomniac has already done that and I am coping him enough as it is. I am now thinking one door, Piano hinge at the bottoms with frame and panel construction, Will that stay true? Or should I split the width up. BTW, it's 31" long X13.5" deep X 11.5" tall. Thanks for looking and any advice you can offer. Dave
Tomorrow, I will make the drawer that goes under the shelf, and the doors.
:eusa_thin I do have a question for ya'll, I had thought I would go with two inset doors, but now I am not sure that would be the best way. I don't want to do a sliding door, 'cause Insomniac has already done that and I am coping him enough as it is. I am now thinking one door, Piano hinge at the bottoms with frame and panel construction, Will that stay true? Or should I split the width up. BTW, it's 31" long X13.5" deep X 11.5" tall. Thanks for looking and any advice you can offer. Dave