JET contractor saw splitter needed

[Frank Berry]

I have had my JET contractor saw for about 13+ years now and removed the blade guard when I set it up.. After all these years of not using the guard, I would like to install just a single splitter in place of the guard.
Does anyone know of a decent bolt on splitter that will install on my old JET?

 

[golfdad]

Google Shark Guard a Frank. Lee makes splinters for almost every saw

 

[Frank Berry]

Thank you Dirk. Will check him out right now.

 

[Frank Berry]

Jeff, checked out the site you sent me and sorry to say that the splitter is just a bit more then I was expecting to pay. For just over a couple hundred, I might as well just keep the stock guard with splitter and remove the plastic guard cover. Not my favorite choice, but really did not want to go that expense. Appreciate the help though.
Frank

 

[Skymaster]

Google Shark Guard a Frank. Lee makes splinters for almost every saw

PLUS34 lee makes good stuff, just get model number, and get a SharkGuard, best thing you can put on any ts. waste of time for just a splitter,

 

[DIYGUY]

You can fab your own out of a piece of 1/8" bar stock. It's readily available from the BORGs, and might take you 20 minutes total. I made one for my Delta CS many moons back. I also fabbed in a spring loaded clamp for it, so that I can install, and remove it in about 2 seconds flat. If I have a spare minute I will upload a pic of it for you.

 

[DIYGUY]

Here are the pics I promised. Hope this helps, and best of luck.

 

[Frank Berry]

Thanks for the pics Mark.