I wasn't sure where else to post this...it IS a woodworking tool.
I want to get this nut off. It is a 15/16" nut but the surrounding hole is only 1 7/32” in diameter. I bought an extra-thin-wall socket, but it is nearly 1 17/64” in diameter – making it nearly a full 1/16” too big. The wall of the socket is only 3/32” thick at the corners. I don't have the tools to turn down a hardened steel socket.
Any ideas?
I want to get this nut off. It is a 15/16" nut but the surrounding hole is only 1 7/32” in diameter. I bought an extra-thin-wall socket, but it is nearly 1 17/64” in diameter – making it nearly a full 1/16” too big. The wall of the socket is only 3/32” thick at the corners. I don't have the tools to turn down a hardened steel socket.
Any ideas?
Last edited: