Was having a constant problem with the pulley wheel on the motor of my grizzly jointer working its way off the shaft- here's the old one:
.
I found a guy on sawmill creek who had the same problem and solved it by changing the sheaves - back to old school belt style. However the sheave on the motor shaft is a two piece and stays on by compression. Had to change the top sheave as well to accommodate the smaller belt.
New lower wheel:
Upper:
Has been working fine for a couple months so I think it's solved. Neat solution...
I found a guy on sawmill creek who had the same problem and solved it by changing the sheaves - back to old school belt style. However the sheave on the motor shaft is a two piece and stays on by compression. Had to change the top sheave as well to accommodate the smaller belt.
New lower wheel:
Upper:
Has been working fine for a couple months so I think it's solved. Neat solution...
