My Supermax 37-2 drum sander conveyor drive died today. The conveyor is driven by a DC motor controlled by a circuit they call the Intellisand Controller part # 72-2280. The obvious repair would be to order a new circuit board - but there is a burned out resistor on the board (5 k resistor that nows reads 3.2 m) I thought I would try swapping this resistor before a new board.
Anybody know where to source this. It is a wire wound but I cannot tell the rated wattage?
Anybody know where to source this. It is a wire wound but I cannot tell the rated wattage?