CJAWFJ2 Jumbo Flat Jaws

[PChristy]

Is this what some of you use to finish turning the bottoms of your bowls to get the tenon of of it
http://www.amazon.com/PSI-Woodworki...ref=sr_1_3?ie=UTF8&s=hi&qid=1250106993&sr=8-3

 

[erasmussen]

I use them some times for reverse turning, some times vacuum, some times donut chuck what ever I find is easiest

 

[Splinter]

I also use a homemade Donut Chuck and today I finished a Longworth Chuck to be used for completing the bottom of bowls. Both of these chucks can be made for a few dollars in bolts and scrap plywood and a small faceplate or a nut that fits your spindle, embedded in a wood puck and bolted to the plywood. The tailstock can be used for support for most of the work.

Lots of info on the web on how to make these two chucks.

 

[PChristy]

I also use a homemade Donut Chuck and today I finished a Longworth Chuck to be used for completing the bottom of bowls. Both of these chucks can be made for a few dollars in bolts and scrap plywood and a small faceplate or a nut that fits your spindle, embedded in a wood puck and bolted to the plywood. The tailstock can be used for support for most of the work.

Lots of info on the web on how to make these two chucks.

That is cool Splinter - thanks for sharing this:icon_thum

 

[woodArtz]

I use Nova Cole Jaws which are similar to what PSI sells. They work for most bowls.

 

[PChristy]

I use Nova Cole Jaws which are similar to what PSI sells. They work for most bowls.

I am just guessing but these jaws wouldn't work to good on green turnings would they:icon_scra